Machine Design When a load W is applied suddenly on a bar of cross-sectional area A, the stress induced in the bar will be W/A W/2A 3W/A 2W/A W/A W/2A 3W/A 2W/A ANSWER DOWNLOAD EXAMIANS APP
Machine Design The velocity factor for precision metallic gears cut with high accuracy and operating at velocities up to 20 m/s is equal to 3/ (3 + v) 0.75/ (0.75 + √v) 6/ (6 + v) 4.5/ (4.5 + v) 3/ (3 + v) 0.75/ (0.75 + √v) 6/ (6 + v) 4.5/ (4.5 + v) ANSWER DOWNLOAD EXAMIANS APP
Machine Design In helical bevel gearing, the axes of shafts are __________ and the teeth are curved. None of these Intersecting Non-intersecting and non-parallel Intersecting and non-parallel None of these Intersecting Non-intersecting and non-parallel Intersecting and non-parallel ANSWER DOWNLOAD EXAMIANS APP
Machine Design In order to determine the stresses in a thin cylinder due to an internal pressure, it is assumed that The effect of curvature of the cylinder wall is neglected The tensile stresses are uniformly distributed over the section of the walls All of these The effect of the restraining action of the heads at the end of the pressure vessel is neglected The effect of curvature of the cylinder wall is neglected The tensile stresses are uniformly distributed over the section of the walls All of these The effect of the restraining action of the heads at the end of the pressure vessel is neglected ANSWER DOWNLOAD EXAMIANS APP
Machine Design In designing a sleeve coupling, outer diameter of the sleeve is taken as (where d = Diameter of the shaft) 2d + 13 mm d + 17 mm 2d + 20 mm 3.5d 2d + 13 mm d + 17 mm 2d + 20 mm 3.5d ANSWER DOWNLOAD EXAMIANS APP
Machine Design When the shaft rotates in anticlockwise direction at slow speed in a bearing, it will Move towards right of the bearing making no metal to metal contact Move towards right of the bearing making the metal to metal contact Move towards left of the bearing making metal to metal contact Have contact at the bottom most of the bearing Move towards right of the bearing making no metal to metal contact Move towards right of the bearing making the metal to metal contact Move towards left of the bearing making metal to metal contact Have contact at the bottom most of the bearing ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS