Manufacturing And Production Technology Hardness of steel greatly improves with Annealing Tempering Cyaniding Normalizing Annealing Tempering Cyaniding Normalizing ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Crater wear is mainly due to the phenomenon known as Oxidation of metals Adhesion of metals Diffusion of metals All of these Oxidation of metals Adhesion of metals Diffusion of metals All of these ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The correct sequence of the following parameters in order of their maximum to minimum influence on tool life is Feed rate, cutting speed, depth of cut Depth of cut, cutting speed, feed rate Feed rate, depth of cut, cutting speed Cutting speed, feed rate, depth of cut Feed rate, cutting speed, depth of cut Depth of cut, cutting speed, feed rate Feed rate, depth of cut, cutting speed Cutting speed, feed rate, depth of cut ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In oblique cutting system, the cutting edge of the tool May not clear the width of the workpiece May clear the width of the workpiece Should always clear the width of the workpiece May or may not clear the width of the workpiece May not clear the width of the workpiece May clear the width of the workpiece Should always clear the width of the workpiece May or may not clear the width of the workpiece ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The average cutting speed for turning brass with a high speed steel tool is 25 to 31 m/min 90 to 120 m/min 60 to 90 m/min 15 to 19 m/min 25 to 31 m/min 90 to 120 m/min 60 to 90 m/min 15 to 19 m/min ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The point angle of a drill, for drilling stainless steel, is 150° 135° 118° 90° 150° 135° 118° 90° ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS