Workshop Technology For smoothing and cleaning out depressions in the mould, a ________ is used. Slick Lifter Swab Gagger Slick Lifter Swab Gagger ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology Structural sections such as rails, angles, I-beams are made by Hot rolling Hot piercing Hot extrusion Hot drawing Hot rolling Hot piercing Hot extrusion Hot drawing ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology When the dimension is expressed as, then the tolerance is 0.01 mm 0.035 mm 0.06 mm 0.025 mm 0.01 mm 0.035 mm 0.06 mm 0.025 mm ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology Tandem drawing of wires and tubes is necessary because Annealing is needed between stages It is not possible to reduce at one stage Accuracy in dimensions is not possible otherwise Surface finish improves after every drawing stage Annealing is needed between stages It is not possible to reduce at one stage Accuracy in dimensions is not possible otherwise Surface finish improves after every drawing stage ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The process used to improve fatigue resistance of the metal by setting up compressive stresses in its surface, is known as Extrusion Cold heading Cold peening Hot piercing Extrusion Cold heading Cold peening Hot piercing ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology Sand wash is a casting defect which Occurs as sand patches on the upper surface of a casting Results in a mismatching of the top and bottom parts of a casting Results in general enlargement of the casting Occurs near the ingates as rough lumps on the surface of a casting Occurs as sand patches on the upper surface of a casting Results in a mismatching of the top and bottom parts of a casting Results in general enlargement of the casting Occurs near the ingates as rough lumps on the surface of a casting ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS