Machine Design For circumferential joint in boilers, the type of joint used is Lap joint with one ring overlapping the other Butt joint with single cover plate Any one of the above Butt joint with double cover plate Lap joint with one ring overlapping the other Butt joint with single cover plate Any one of the above Butt joint with double cover plate ANSWER DOWNLOAD EXAMIANS APP
Machine Design For a bevel gear having the pitch angle θ, the ratio of formative number of teeth (TE) to actual number of teeth (T) is 1/sinθ 1/tanθ 1/cosθ sinθ cosθ 1/sinθ 1/tanθ 1/cosθ sinθ cosθ ANSWER DOWNLOAD EXAMIANS APP
Machine Design In the case of an elastic bar fixed at upper end and loaded by a falling weight at lower end, the shock load produced can be decreased by Increasing the cross-section area of bar Would depend upon other factors Decreasing the cross-section area of bar Remain unaffected with cross-section area Increasing the cross-section area of bar Would depend upon other factors Decreasing the cross-section area of bar Remain unaffected with cross-section area ANSWER DOWNLOAD EXAMIANS APP
Machine Design The rolling contact bearings are known as Thin lubricated bearings Plastic bearings Thick lubricated bearings Antifriction bearings Thin lubricated bearings Plastic bearings Thick lubricated bearings Antifriction bearings ANSWER DOWNLOAD EXAMIANS APP
Machine Design According to Indian standards, total numbers of fundamental deviations are 20 10 15 25 20 10 15 25 ANSWER DOWNLOAD EXAMIANS APP
Machine Design For standard coarse threads of nut, the threads will be as strong in failure by shear as the bolt in tension, if the height of nut (h) is approximately 0.7 times 0.8 times 0.4 times 0.6 times 0.7 times 0.8 times 0.4 times 0.6 times ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS