Machine Design For a shaft diameter of 100 mm, the number of bolts in a flange coupling should be 4 6 10 8 4 6 10 8 ANSWER DOWNLOAD EXAMIANS APP
Machine Design The included angle between the sides of V-belt is 45° 38° 40° 60° 45° 38° 40° 60° ANSWER DOWNLOAD EXAMIANS APP
Machine Design Basic hole is one Whose upper deviation is zero Whose lower as well as upper deviations are zero Whose lower deviation is zero Does not exist Whose upper deviation is zero Whose lower as well as upper deviations are zero Whose lower deviation is zero Does not exist ANSWER DOWNLOAD EXAMIANS APP
Machine Design The diameter of knuckle pin in a knuckle joint is usually taken as (where d = Diameter of the rod) d 0.8 d 1.2 d 0.5 d d 0.8 d 1.2 d 0.5 d ANSWER DOWNLOAD EXAMIANS APP
Machine Design The property of a bearing material which has the ability to accommodate shaft deflections and bearing inaccuracies by plastic deformation without excessive wear and heating, is known as Embeddability Comformability Bondability Fatigue strength Embeddability Comformability Bondability Fatigue strength ANSWER DOWNLOAD EXAMIANS APP
Machine Design Gears are casted by Permanent mould casting Centrifugal casting Sand mould casting Slush casting Permanent mould casting Centrifugal casting Sand mould casting Slush casting ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS