Workshop Technology Cutting and forming operations can be performed in a single operation in a Compound die Progressive die Combination die Simple die Compound die Progressive die Combination die Simple die ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology In backhand welding, the angle between the welding torch and the work is kept as 30°-40° 40°-50° 60°-70° 50°-60° 30°-40° 40°-50° 60°-70° 50°-60° ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology For welding plates of thickness less than 5 mm, its edges Should have a double-V or U-groove on one side Do not require bevelling Should have a double-V or U-groove on both sides Should be bevelled to a single-V or U-groove Should have a double-V or U-groove on one side Do not require bevelling Should have a double-V or U-groove on both sides Should be bevelled to a single-V or U-groove ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology A ring gauge is used to Check the diameter of shafts or studs Test the accuracy of holes Check the clearance between two mating surfaces All of these Check the diameter of shafts or studs Test the accuracy of holes Check the clearance between two mating surfaces All of these ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The recrystallisation temperature of steel is 400°C None of these 600°C 800°C 400°C None of these 600°C 800°C ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The fullers are used For punching a hole For necking down a piece of work To finish the punched hole For finishing flat surfaces For punching a hole For necking down a piece of work To finish the punched hole For finishing flat surfaces ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS