Computer Hardware COM1 is typically represented by which of the following? 15 pin port 9 pin male port 9 pin female port 25 pin male port 15 pin port 9 pin male port 9 pin female port 25 pin male port ANSWER DOWNLOAD EXAMIANS APP
Computer Hardware After displaying the directory of a floppy disk, a different floppy is inserted into the drive. The contents of the original floppy continue to display regardless of the director requests on the other floppies placed in the drive. You remove the drive in question and install it into your test system, and it does not exhibit the problem. You should next replace the: None of these System's power supply System's floppy drive device driver Original IDE controller Floppy drive ribbon cable None of these System's power supply System's floppy drive device driver Original IDE controller Floppy drive ribbon cable ANSWER DOWNLOAD EXAMIANS APP
Computer Hardware You suspect a virus has entered your computer. What will not be affected by the virus? Program files Floppy disks None of these CMOS Boot sector Program files Floppy disks None of these CMOS Boot sector ANSWER DOWNLOAD EXAMIANS APP
Computer Hardware Which controller would support an external CD-ROM drive? ESDI SCSI ARLL MFM None of these ESDI SCSI ARLL MFM None of these ANSWER DOWNLOAD EXAMIANS APP
Computer Hardware You have just installed a new internal PCI modem on you desktop. It will not dial out. what is the problem? The port speed is set too high None of these the modem has not been set up in control panel properties the phone line out of the wall is plugged into the phone port on the modem card the phone line is plugged into the line-in port on the modem card The port speed is set too high None of these the modem has not been set up in control panel properties the phone line out of the wall is plugged into the phone port on the modem card the phone line is plugged into the line-in port on the modem card ANSWER DOWNLOAD EXAMIANS APP
Computer Hardware To install a second IDE drive into a computer, you must Verify that you attach the drive to the connector at the end of the ribbon cable Set the master-slave jumper to slave on the second drive Verify that you define the new drive as D: in the CMOS setup Use the IDE configuration software to set the new drive as slave Verify that you attach the drive to the connector at the end of the ribbon cable Set the master-slave jumper to slave on the second drive Verify that you define the new drive as D: in the CMOS setup Use the IDE configuration software to set the new drive as slave ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS