Mass Transfer Calculation of mass transfer co-efficient is mostly/normally done using __________ theory. Penetration Film None of the listed here Surface renewal Penetration Film None of the listed here Surface renewal ANSWER DOWNLOAD EXAMIANS APP
Mass Transfer A 25 cm x 25 cm x 1 cm flat sheet weighing 1.2 kg initially was dried from both sides under constant drying rate conditions. It took 1500 seconds for the weight of the sheet to reduce to 1.05 kg. Another 1m x 1m x 1cm flat sheet of the same material is to be dried from one side only.Under the same constant drying rate conditions, the time required for drying (in seconds) from its initial weight of 19.2 kg to 17.6 kg is 1500 1000 2500 2000 1500 1000 2500 2000 ANSWER DOWNLOAD EXAMIANS APP
Mass Transfer In a distillation column, with increase in the reflux ratio, the heat removed in the cooler Decreases And the heat required in reboiler decreases Remains unaffected Increases Decreases And the heat required in reboiler decreases Remains unaffected Increases ANSWER DOWNLOAD EXAMIANS APP
Mass Transfer In case of cooling towers, the ratio of the rates of heat and mass transfer is indicated by the __________ number. Sherwood None of these Lewis Grashoff Sherwood None of these Lewis Grashoff ANSWER DOWNLOAD EXAMIANS APP
Mass Transfer Leaching of coffee from coffee beans is done by Hot water Dilute H₂SO₄ (hot) Hexane Lime water Hot water Dilute H₂SO₄ (hot) Hexane Lime water ANSWER DOWNLOAD EXAMIANS APP
Mass Transfer Which of the following processes is not an example of adsorption applied to gaseous separations? Removal of objectionable odour and impurities from industrial gases Dehumidification of air and gas Recovery of valuable solvent vapors from dilute mixture with air and other gases Decolouration of yellow glycerene Removal of objectionable odour and impurities from industrial gases Dehumidification of air and gas Recovery of valuable solvent vapors from dilute mixture with air and other gases Decolouration of yellow glycerene ANSWER DOWNLOAD EXAMIANS APP