Machine Design Antifriction bearings are Thin lubricated bearings Hydrodynamic bearings None of these Sleeve bearings Thin lubricated bearings Hydrodynamic bearings None of these Sleeve bearings ANSWER DOWNLOAD EXAMIANS APP
Machine Design When the shaft rotates in anticlockwise direction at high speed in a bearing, it will Move towards right of the bearing making metal to metal contact Move towards right of the bearing making no metal to metal contact Move towards left of the bearing making metal to metal contact Have contact at the bottom most of the bearing Move towards right of the bearing making metal to metal contact Move towards right of the bearing making no metal to metal contact Move towards left of the bearing making metal to metal contact Have contact at the bottom most of the bearing ANSWER DOWNLOAD EXAMIANS APP
Machine Design The design calculations for members subject to fluctuating loads with the same factor of safety, yield the most conservative estimates when using Goodman relation Soderberg relation Gerber relation None of these Goodman relation Soderberg relation Gerber relation None of these ANSWER DOWNLOAD EXAMIANS APP
Machine Design A hollow saddle key is A taper key which fits in a key way of the hub and the bottom of the key is shaped to fit the curved surface of the shaft A taper key which fits in a key way of the hub and is flat on the shaft A taper key which fits half in the key way of hub and half in the key way of shaft Provided in pairs at right angles and each key is to withstand torsion in one direction only A taper key which fits in a key way of the hub and the bottom of the key is shaped to fit the curved surface of the shaft A taper key which fits in a key way of the hub and is flat on the shaft A taper key which fits half in the key way of hub and half in the key way of shaft Provided in pairs at right angles and each key is to withstand torsion in one direction only ANSWER DOWNLOAD EXAMIANS APP
Machine Design A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where σ = Stress for a plate with no hole i.e. nominal stress) σ [1 + (b/3a)] σ [1 + (b/2a)] σ [1 + (3a/b)] σ [1 + (2a/b)] σ [1 + (b/3a)] σ [1 + (b/2a)] σ [1 + (3a/b)] σ [1 + (2a/b)] ANSWER DOWNLOAD EXAMIANS APP
Machine Design When screw threads are to be used in a situation where power is being transmitted in one direction only, then the screw threads suitable for this will be Acme threads Knuckle threads Buttress threads Square threads Acme threads Knuckle threads Buttress threads Square threads ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS