Machine Design An Involute pinion and gear are in mesh. If both have the same size of addendum, then there will be interference between the Tip of both gear and pinion Flanks of both gear and pinion Tip of the gear and flank of pinion Tip of the pinion and flank of gear Tip of both gear and pinion Flanks of both gear and pinion Tip of the gear and flank of pinion Tip of the pinion and flank of gear ANSWER DOWNLOAD EXAMIANS APP
Machine Design The helix angle for single helical gears ranges from 10° to 15° 35° to 50° 20° to 35° 15° to 20° 10° to 15° 35° to 50° 20° to 35° 15° to 20° ANSWER DOWNLOAD EXAMIANS APP
Machine Design In order to obtain bolt of uniform strength Increase its length Drill an axial hole through head up to threaded portion so that shank area is equal to root area of thread Increase shank diameter Tighten die bolt properly Increase its length Drill an axial hole through head up to threaded portion so that shank area is equal to root area of thread Increase shank diameter Tighten die bolt properly ANSWER DOWNLOAD EXAMIANS APP
Machine Design The elasticity is the property of a material which enables it to Resists fracture due to high impact loads Draw into wires by the application of a tensile force Retain deformation produced under load permanently Regains its original shape after deformation when the external forces are removed Resists fracture due to high impact loads Draw into wires by the application of a tensile force Retain deformation produced under load permanently Regains its original shape after deformation when the external forces are removed ANSWER DOWNLOAD EXAMIANS APP
Machine Design According to Indian standards, the diameter of rivet hole is made larger than the basic size of rivet by All of these 2 mm for rivet diameter from 39 mm to 48 mm 0.5 mm up to rivet diameter of 24 mm 1 mm for rivet diameter from 27 mm to 36 mm All of these 2 mm for rivet diameter from 39 mm to 48 mm 0.5 mm up to rivet diameter of 24 mm 1 mm for rivet diameter from 27 mm to 36 mm ANSWER DOWNLOAD EXAMIANS APP
Machine Design When a material is subjected to fatigue loading, the ratio of the endurance limit to the ultimate tensile strength is 0.65 0.2 0.5 0.35 0.65 0.2 0.5 0.35 ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS