Manufacturing And Production Technology Allowance in limits and fits refers to Difference between maximum and minimum sizes of hole Difference between maximum and minimum sizes of shaft Maximum clearance between shaft and hole Minimum clearance between shaft and hole Difference between maximum and minimum sizes of hole Difference between maximum and minimum sizes of shaft Maximum clearance between shaft and hole Minimum clearance between shaft and hole ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology What is the type of joining process called, where the parts to be welded are kept in contact and rotated relative to each other and axial pressure is applied when the desired temperature is obtained? Electron beam welding Friction welding Forge welding Ultrasonic welding Electron beam welding Friction welding Forge welding Ultrasonic welding ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The work or surface speed for cylindrical grinding varies from 10 to 20 m/min 20 to 30 m/min 5 to 10 m/min 40 to 60 m/min 10 to 20 m/min 20 to 30 m/min 5 to 10 m/min 40 to 60 m/min ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The percentage of carbon in gray cast iron is in the range of 3 to 4 percent 0.25 to 0.75 percent 1.25 to 1.75 percent 8 to 10 percent 3 to 4 percent 0.25 to 0.75 percent 1.25 to 1.75 percent 8 to 10 percent ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The tool life is said to be over if All of these There is sudden increase in cutting forces and power consumption Poor surface finish is obtained Overheating and fuming due to heat of friction starts All of these There is sudden increase in cutting forces and power consumption Poor surface finish is obtained Overheating and fuming due to heat of friction starts ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Side rake angle of a single point cutting tool is the angle By which the face of the tool is inclined sideways Between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base By which the face of the tool is inclined towards back Between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of the tool By which the face of the tool is inclined sideways Between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base By which the face of the tool is inclined towards back Between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of the tool ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS