Manufacturing And Production Technology Which of the following statement is correct in regard to centreless grinding? All of these It is a continuous process and adopted for production work The workpiece is supported throughout its entire length as grinding takes place It requires no holding device for the work All of these It is a continuous process and adopted for production work The workpiece is supported throughout its entire length as grinding takes place It requires no holding device for the work ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The stroke of a shaping machine is 250 mm. It makes 30 double strokes per minute. The overall average speed of operation is 5 m/min 3.75 m/min 7.5 m/min 15 m/min 5 m/min 3.75 m/min 7.5 m/min 15 m/min ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In order to have interference fit, it is essential that the lower limit of the shaft should be Lesser than the upper limit of the hole Greater than the lower limit of the hole Greater than the upper limit of the hole Lesser than the lower limit of the hole Lesser than the upper limit of the hole Greater than the lower limit of the hole Greater than the upper limit of the hole Lesser than the lower limit of the hole ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Work speed of circular electrode of 220 mm diameter for carrying out seam welding at 4 welds per cm on 1.6 mm thick mild steel tube. Welding cycle consists of 3 cycles ‘on’ and 2 cycles ‘off’ Power supply is at 50 Hz. Calculate R.P.M. and energy requirement of the above circular electrodes assuming effective resistance between electrodes as 100 ohm. 22 rpm, 600 joules 2.17 rpm, 600 joules 5.03 rpm, 600 joules 6.8 rpm, 6 joules 22 rpm, 600 joules 2.17 rpm, 600 joules 5.03 rpm, 600 joules 6.8 rpm, 6 joules ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In order to obtain a surface finish in the range of 0.75 μm to 1.25 μm , the operation used is called. Lapping Honing Grinding Buffing Lapping Honing Grinding Buffing ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The common welding error that occurs due to wrong speed, faulty preparation, and high / low current, improper electrode size is called? Porous weld Warping Poor fusion Distortion Porous weld Warping Poor fusion Distortion ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS