Power Systems A transmission line has impedance of (0.005 + j0.05) pu. Find the line at which maximum value of negative DC off set current is produced, if it is applied with Vm cosωt? 2.63 msec 9.68 1.47 msec 4.68 msec 2.63 msec 9.68 1.47 msec 4.68 msec ANSWER DOWNLOAD EXAMIANS APP
Power Systems The rating of CB is in terms of volt - ampere. VAR. current. voltage. volt - ampere. VAR. current. voltage. ANSWER DOWNLOAD EXAMIANS APP
Power Systems Which of the following plants is/are base load plants pump storage both 1 and 2 nuclear run off river pump storage both 1 and 2 nuclear run off river ANSWER DOWNLOAD EXAMIANS APP
Power Systems The neutral of 10 MVA, 11 kV alternator is earthed through a resistance of 5 ohms. The fault ready is set to operate at 0.75 A. The current transformers have a ratio of 1000/5. What is the percentage of the alternator winding is protected? 85% 11.8% 15% 88.2% 85% 11.8% 15% 88.2% ANSWER DOWNLOAD EXAMIANS APP
Power Systems The inductance of single phase two wire line is given by 0.4×10-7× ln(d/r') H/m 4×10-7× ln(d/r') H/m 0.4×10-7× ln(r'/d) H/m 4×10-7× ln(r'/d) H/m 0.4×10-7× ln(d/r') H/m 4×10-7× ln(d/r') H/m 0.4×10-7× ln(r'/d) H/m 4×10-7× ln(r'/d) H/m ANSWER DOWNLOAD EXAMIANS APP
Power Systems A lossless power system has to serve a load of 250 MW. There are two generators(G1 and G2) in the system with cost curves C1 and C2 respectively defined as follows: C1 = PG1+0.055P²G1 C2 = 3 PG2 + 0.03 P²G2 Where PG1 and PG2 are the MW injections from generators G1 and G2 respectively. Thus, the minimum cost dispatch will be PG1 = 250 MW and PG2 = 0 MW PG1 = 150 MW and PG2 = 100 MW PG1 = 0 MW and PG2 = 250 MW PG1 = 100 MW and PG2 = 150 MW PG1 = 250 MW and PG2 = 0 MW PG1 = 150 MW and PG2 = 100 MW PG1 = 0 MW and PG2 = 250 MW PG1 = 100 MW and PG2 = 150 MW ANSWER DOWNLOAD EXAMIANS APP