Manufacturing And Production Technology A single point thread cutting tool should ideally have Negative rake angle Zero rake angle Positive rake angle Point angle Negative rake angle Zero rake angle Positive rake angle Point angle ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In a metal arc welding process, a gas metal arc welding with magnetized flux is used and can be done in all the positions i.e. flat position, vertical position or inclined position. Spray transfer Globular transfer Dip transfer GMAW practice Spray transfer Globular transfer Dip transfer GMAW practice ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The material which on machining produces chips with built up edge is Ductile material Brittle material Hard material Tough material Ductile material Brittle material Hard material Tough material ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In American Standard Association (ASA) system, if the tool nomenclature is 8-6-5-5-10-15-2 mm, then the side rake angle will be 6° 10° 5° 8° 6° 10° 5° 8° ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The main purpose of a boring operation, as compared to drilling, is to Correct the hole Enlarge the existing hole Finish the drilled hole Drill a hole Correct the hole Enlarge the existing hole Finish the drilled hole Drill a hole ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In metal machining, the zone where the maximum heat is generated due to the plastic deformation of metal, is called None of these Work-tool contact zone Shear zone Friction zone None of these Work-tool contact zone Shear zone Friction zone ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS