Manufacturing And Production Technology A push broach as compared to pull broach Is short and stocky Has less number of teeth All of the listed here Removes less material for each pass of the tool Is short and stocky Has less number of teeth All of the listed here Removes less material for each pass of the tool ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A drill mainly used in drilling brass, copper or softer materials, is Tapered shank twist drill Parallel shank twist drill Straight fluted drill Flat drill Tapered shank twist drill Parallel shank twist drill Straight fluted drill Flat drill ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology An important geometrical quantity in the cutting of metals which can be used as a criterion for machinability of metals is Tool geometry Cutting speed Feed rate Shear angle Tool geometry Cutting speed Feed rate Shear angle ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The relation between tool life (T) and cutting speed (V) is VTn = Constant. In this relation, the value of n depends upon Type of chip produced Tool material Work material Working conditions Type of chip produced Tool material Work material Working conditions ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology High speed steel cutting tools operate at cutting speeds _________ than carbon steel tools. 5 to 8 times higher 2 to 3 times higher 2 to 3 times lower 8 to 20 times higher 5 to 8 times higher 2 to 3 times higher 2 to 3 times lower 8 to 20 times higher ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In an interchangeable assembly, shafts of size 25.000 -0.010⁺⁰∙⁰⁴⁰ mm mate with holes of size 25.000 -0.020⁺⁰∙⁰³⁰, the maximum interference (in microns) in the assembly is 10 20 30 40 10 20 30 40 ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS