Machine Design A fast and loose pulley drive is used when Shafts are arranged parallel and rotate in the same directions Driven shaft is to be started or stopped whenever desired without interfering with the driving shaft Shafts are arranged parallel and rotate in the opposite directions Shafts are arranged at right angles and rotate in one definite direction Shafts are arranged parallel and rotate in the same directions Driven shaft is to be started or stopped whenever desired without interfering with the driving shaft Shafts are arranged parallel and rotate in the opposite directions Shafts are arranged at right angles and rotate in one definite direction ANSWER DOWNLOAD EXAMIANS APP
Machine Design When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl's stress factor, and W = Axial compressive load on the spring) (WD/ πd3) × K (2WD/ πd3) × K (4WD/ πd3) × K (8WD/ πd3) × K (WD/ πd3) × K (2WD/ πd3) × K (4WD/ πd3) × K (8WD/ πd3) × K ANSWER DOWNLOAD EXAMIANS APP
Machine Design The groove angle of pulleys for V-belt is 420 to 450 300 to 320 More than 400 340 to 360 420 to 450 300 to 320 More than 400 340 to 360 ANSWER DOWNLOAD EXAMIANS APP
Machine Design Lewis equation is applied To stronger of the pinion or gear To weaker of the pinion or gear Only to the gear Only to the pinion To stronger of the pinion or gear To weaker of the pinion or gear Only to the gear Only to the pinion ANSWER DOWNLOAD EXAMIANS APP
Machine Design The deflection of a cantilever beam under load W is 8. If its width is halved, then the deflection under load W will be 44045 44047 43929 43869 44045 44047 43929 43869 ANSWER DOWNLOAD EXAMIANS APP
Machine Design If a material fails below its yield point, failure would be due to Straining Sudden loading Creep Fatigue Straining Sudden loading Creep Fatigue ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS