Analog Electronics A electric current ratio of IC / IE is usually less than one and is called θ. É. β. α. θ. É. β. α. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics A dc power supply has no-load voltage of 30v,and a full-load voltage of 25v at full-load current of 1A.Its output resistance & load regulation ,respectively are 25 Ω & 16.7 % 25 Ω & 20 % 5 Ω & 20 % 5 Ω & 16.7 % 25 Ω & 16.7 % 25 Ω & 20 % 5 Ω & 20 % 5 Ω & 16.7 % ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics If the emitter resistor is open, the collector voltage is low. high. unchanged. unknown. low. high. unchanged. unknown. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics What is the most important fact about the collector current? It equals the base current divided by the current gain. It is small. It approximately equals the emitter current. It is measured in milliampere. It equals the base current divided by the current gain. It is small. It approximately equals the emitter current. It is measured in milliampere. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics The input offset electric current is usually equal to zero. less than the input bias current. less than the input offset voltage. unimportant when a base resistor is used. equal to zero. less than the input bias current. less than the input offset voltage. unimportant when a base resistor is used. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics The Q-point in a voltage amplifier is selected in the middle of the active region because the circuit needs a small. it gives better stability. the biasing circuit then need less number of resistors. it gives distortions less output. the circuit needs a small. it gives better stability. the biasing circuit then need less number of resistors. it gives distortions less output. ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS