Measurement and Instrumentation A dynamometer wattmeter can be used for Any of the listed here AC only DC only Both DC and AC Any of the listed here AC only DC only Both DC and AC ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The coil of a moving iron instrument has a resistance of 500 ohm and inductance of 1 H. It reads 250 V when a 250 V DC is applied. It series resistance is 2000 ohms its reading when fed by 250 V, 50 Hz AC will be 248 V. 252 V. 260 V. 250 V. 248 V. 252 V. 260 V. 250 V. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A single phase load is connected between R and Y terminals of a 415 V, symmetrical, 3-phase, 4 wire system with phase sequence RYB. A wattmeter is connected in the system as shown in figure. The power factor of the load is 0.8 lagging. The wattmeter will read - 597 W. - 795 W. + 597 W. + 795 W. - 597 W. - 795 W. + 597 W. + 795 W. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The maximum percentage error in the sum of two voltage measurements when V1 = 100V ± 1% and V2 = 80V ± 5% is ± 6% ± 4% ± 2.8% ± 3% ± 6% ± 4% ± 2.8% ± 3% ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A spring-controlled moving iron voltmeter draws a current of 1 mA for full scale value of 100V. If it draws a current of 0.5 mA, the meter reading is 200 V. 50 V. 25 V. 100 V. 200 V. 50 V. 25 V. 100 V. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A DC potentiometer is the best means available for the measurement of DC voltage because The precision in measurment is independent of the type of the defector used. It is based on null balance technique. It is possible to standardize before a measurement is undertaken. None of above. The precision in measurment is independent of the type of the defector used. It is based on null balance technique. It is possible to standardize before a measurement is undertaken. None of above. ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS