Workshop Technology A diamond pointed chisel is used for cutting V-shaped grooves Flat surfaces Key-ways Grooves V-shaped grooves Flat surfaces Key-ways Grooves ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology A file with 20 teeth in 25 mm is called Bastard file Smooth file Rough file Second cut file Bastard file Smooth file Rough file Second cut file ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology A casting defect which occurs due to improper venting of sand is known as Swell Shift Blow holes Cold shuts Swell Shift Blow holes Cold shuts ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology For gas welding, the pressure desired at the welding torch for acetylene is 70 to 280 kN/m² 7 to 103 kN/m² 560 to 840 kN/m² 280 to 560 kN/m² 70 to 280 kN/m² 7 to 103 kN/m² 560 to 840 kN/m² 280 to 560 kN/m² ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology When a pattern is made in three parts, the ________ is known as a drag. None of these Middle part Top part Bottom part None of these Middle part Top part Bottom part ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The parts of circular cross-section which are symmetrical about the axis of rotation are made by Hot spinning Hot drawing Hot forging Hot extrusion Hot spinning Hot drawing Hot forging Hot extrusion ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS