Machine Design A bolt Has a head on one end and a nut fitted to the other Has both the ends threaded Has head at one end and other end fits into a tapped hole in the other part to be joined Is provided with pointed threads Has a head on one end and a nut fitted to the other Has both the ends threaded Has head at one end and other end fits into a tapped hole in the other part to be joined Is provided with pointed threads ANSWER DOWNLOAD EXAMIANS APP
Machine Design An open belt drive is used when Shafts are arranged parallel and rotate in the same directions Shafts are arranged at right angles and rotate in one definite direction Shafts are arranged parallel and rotate in the opposite directions Driven shaft is to be started or stopped whenever desired without interfering with the driving shaft Shafts are arranged parallel and rotate in the same directions Shafts are arranged at right angles and rotate in one definite direction Shafts are arranged parallel and rotate in the opposite directions Driven shaft is to be started or stopped whenever desired without interfering with the driving shaft ANSWER DOWNLOAD EXAMIANS APP
Machine Design When a nut is tightened by placing a washer below it, the bolt will be subjected to following type of loads Compression Shear Combined loads Tension Compression Shear Combined loads Tension ANSWER DOWNLOAD EXAMIANS APP
Machine Design Fabric belts are used in industrial applications because They can work at high temperature None of these They are unaffected by moisture and humidity They are cheap They can work at high temperature None of these They are unaffected by moisture and humidity They are cheap ANSWER DOWNLOAD EXAMIANS APP
Machine Design The objective of 'crowning' of the flat pulleys of belt drive is to Prevent the belt joint from damaging the belt surface Prevent the belt from running off the pulley Increase the belt velocity Increase the power transmission capacity Prevent the belt joint from damaging the belt surface Prevent the belt from running off the pulley Increase the belt velocity Increase the power transmission capacity ANSWER DOWNLOAD EXAMIANS APP
Machine Design The permissible stress in the fillet weld is 100 N/mm². The fillet weld has equal leg lengths of 15 mm each. The allowable shearing load on the weldment per cm length of the weld is 15 kN 22.5 kN 7.5 kN 10.6 kN 15 kN 22.5 kN 7.5 kN 10.6 kN ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS