Machine Design A backing ring is used inside the pipe joint when making a Sleeve weld Socket weld Butt weld Fillet weld Sleeve weld Socket weld Butt weld Fillet weld ANSWER DOWNLOAD EXAMIANS APP
Machine Design The lower deviation is the algebraic difference between the Maximum limit and the basic size None of these Minimum limit and the basic size Actual size and the corresponding basic size Maximum limit and the basic size None of these Minimum limit and the basic size Actual size and the corresponding basic size ANSWER DOWNLOAD EXAMIANS APP
Machine Design In the case of an elastic bar fixed at upper end and loaded by a falling weight at lower end, the shock load produced can be decreased by Increasing the cross-section area of bar Decreasing the cross-section area of bar Remain unaffected with cross-section area Would depend upon other factors Increasing the cross-section area of bar Decreasing the cross-section area of bar Remain unaffected with cross-section area Would depend upon other factors ANSWER DOWNLOAD EXAMIANS APP
Machine Design The taper on a rectangular sunk key is 1 in 16 1 in 100 1 in 32 1 in 48 1 in 16 1 in 100 1 in 32 1 in 48 ANSWER DOWNLOAD EXAMIANS APP
Machine Design An open belt drive is used when Shafts are arranged parallel and rotate in the opposite directions Shafts are arranged at right angles and rotate in one definite direction Driven shaft is to be started or stopped whenever desired without interfering with the driving shaft Shafts are arranged parallel and rotate in the same directions Shafts are arranged parallel and rotate in the opposite directions Shafts are arranged at right angles and rotate in one definite direction Driven shaft is to be started or stopped whenever desired without interfering with the driving shaft Shafts are arranged parallel and rotate in the same directions ANSWER DOWNLOAD EXAMIANS APP
Machine Design The ratio of driving tensions for flat belts, neglecting centrifugal tension, is (where T₁, and T₂ = Tensions on the tight and slack sides of belt respectively, μ = Coefficient of friction, between the belt and pulley, and θ = Angle of contact) T₁/T₂ = log μθ T₁/T₂ = μθ T₁/T₂ =eμθ log (T₁/T₂) = μθ T₁/T₂ = log μθ T₁/T₂ = μθ T₁/T₂ =eμθ log (T₁/T₂) = μθ ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS