Computer Networking You are trying to decide which type of network you will use at your office, and you want the type that will provide communication and avoid collisions on the cable. Which of the following is the best choice? ARCnet CSMA/CA Ethernet Token-Ring CSMA/CD ARCnet CSMA/CA Ethernet Token-Ring CSMA/CD ANSWER DOWNLOAD EXAMIANS APP
Computer Networking Which utility is an all-purpose tool for troubleshooting TCP/IP problems? Netstat NBTSTAT PING None of these Hostname Netstat NBTSTAT PING None of these Hostname ANSWER DOWNLOAD EXAMIANS APP
Computer Networking To enable EIGRP, which of the following would you use?1. Router1(config-if)# ipv6 ospf 10 area 0.0.0.02. Router1(config-if)# ipv6 router rip 13. Router1(config)# ipv6 router eigrp 104. Router1(config-rtr)# no shutdown5. Router1(config-if)# ipv6 eigrp 10 3, 4 and 5 5 only 1, 3 and 5 1 and 3 3, 4 and 5 5 only 1, 3 and 5 1 and 3 ANSWER DOWNLOAD EXAMIANS APP
Computer Networking Which layer 1 devices can be used to enlarge the area covered by a single LAN segment?1. Switch2. NIC3. Hub4. Repeater5. RJ45 transceiver 1 and 3 3 and 4 1 only 5 only All of these 1 and 3 3 and 4 1 only 5 only All of these ANSWER DOWNLOAD EXAMIANS APP
Computer Networking Which two of the following commands will place network 10.2.3.0/24 into area 0?1. router eigrp 102. router ospf 103. network 10.0.0.04. network 10.2.3.0 0.0.0.255 area05. network 10.2.3.0 0.0.0.255 area 0 2 and 5 2, 4, and 5 3 and 4 1 and 4 2 and 5 2, 4, and 5 3 and 4 1 and 4 ANSWER DOWNLOAD EXAMIANS APP
Computer Networking In Cisco's Unified Wireless Solution, what is the split-MAC architecture? The split-MAC architecture uses MAC addresses to create a forward/filter table and break up broadcast domains. The split-MAC architecture uses MAC addresses to create a forward/filter table and break up collision domains. The split-MAC architecture uses MAC addresses on the wireless network and IP addresses on the wired network. The split-MAC architecture allows the splitting of 802.11 protocol packets between the AP and the controller to allow processing by both devices. The split-MAC architecture uses MAC addresses to create a forward/filter table and break up broadcast domains. The split-MAC architecture uses MAC addresses to create a forward/filter table and break up collision domains. The split-MAC architecture uses MAC addresses on the wireless network and IP addresses on the wired network. The split-MAC architecture allows the splitting of 802.11 protocol packets between the AP and the controller to allow processing by both devices. ANSWER DOWNLOAD EXAMIANS APP