Computer Hardware
You are installing an IDE hard drive that will be your boot drive. Which is the correct order of steps that need to be followed?

jumper properly, auto-detect in CMOS, regular format
jumper properly, auto-detect(or configure manually) in CMOS, low level format, high level format, partition
jumper properly, partition, auto-detect(or configure manually in CMOS, high level format with /s switch
jumper properly, partition, low level format, high level format
jumper properly, auto-detect(or configure manually) in CMOS, partition, high level format with / s switch

ANSWER DOWNLOAD EXAMIANS APP

Computer Hardware
What is the most likely cause of an "FDD controller Failure" error message?

None of these
you forgot to flash CMOS
you did not set the jumper on the floppy drive to drive A
your computer's floppy drive is defective
you installed the floppy disk drive cable backward

ANSWER DOWNLOAD EXAMIANS APP