Workshop Technology The cutting edge of a chisel should be Case hardened Tempered Hardened and tempered Hardened Case hardened Tempered Hardened and tempered Hardened ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology For gas welding, the pressure desired at the welding torch for acetylene is 7 to 103 kN/m² 280 to 560 kN/m² 70 to 280 kN/m² 560 to 840 kN/m² 7 to 103 kN/m² 280 to 560 kN/m² 70 to 280 kN/m² 560 to 840 kN/m² ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The fullers are used For finishing flat surfaces For punching a hole To finish the punched hole For necking down a piece of work For finishing flat surfaces For punching a hole To finish the punched hole For necking down a piece of work ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology A ring gauge is used to All of these Test the accuracy of holes Check the diameter of shafts or studs Check the clearance between two mating surfaces All of these Test the accuracy of holes Check the diameter of shafts or studs Check the clearance between two mating surfaces ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology Lap joints are employed on plates having thickness Above 25 mm 5 to 10 mm Less than 3 mm 12.5 mm Above 25 mm 5 to 10 mm Less than 3 mm 12.5 mm ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS