Machine Design Which one of the following is a positive drive? Rope drive Crossed flat belt drive Chain drive V-belt drive Rope drive Crossed flat belt drive Chain drive V-belt drive ANSWER DOWNLOAD EXAMIANS APP
Machine Design The draw of cotter should not be more than 8 mm 3 mm 6 mm 12 mm 8 mm 3 mm 6 mm 12 mm ANSWER DOWNLOAD EXAMIANS APP
Machine Design When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl's stress factor, and W = Axial compressive load on the spring) (8WD/ πd3) × K (2WD/ πd3) × K (4WD/ πd3) × K (WD/ πd3) × K (8WD/ πd3) × K (2WD/ πd3) × K (4WD/ πd3) × K (WD/ πd3) × K ANSWER DOWNLOAD EXAMIANS APP
Machine Design The crest diameter of a screw thread is same as Core diameter Pitch diameter Major diameter Minor diameter Core diameter Pitch diameter Major diameter Minor diameter ANSWER DOWNLOAD EXAMIANS APP
Machine Design The notch angle of the Izod impact test specimen is 30° 45° 20° 10° 30° 45° 20° 10° ANSWER DOWNLOAD EXAMIANS APP
Machine Design The flank of the tooth is the Surface of the top of the tooth Surface of the tooth above the pitch surface Width of the tooth measured along the pitch circle Surface of the tooth below the pitch surface Surface of the top of the tooth Surface of the tooth above the pitch surface Width of the tooth measured along the pitch circle Surface of the tooth below the pitch surface ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS