Which of the following is used for the measurement of the insulation resistance?

SSC JE Electrical 2018 with solution SET-1
Which of the following is used for the measurement of the insulation resistance?

Wattmeter

Ammeter

Voltmeter

Megger

Wattmeter

Ammeter

Voltmeter

Megger

ANSWER DOWNLOAD EXAMIANS APP

SSC JE Electrical 2018 with solution SET-1
Scott connections are used for

Three Phase to Single Phase transformation

Any of the above

Single-phase to three-phase transformation

Three-phase to two-phase transformation

Three Phase to Single Phase transformation

Any of the above

Single-phase to three-phase transformation

Three-phase to two-phase transformation

ANSWER EXPLANATION DOWNLOAD EXAMIANS APP

SSC JE Electrical 2018 with solution SET-1
The output Resistance (in kΩ) of the common base transistor is of the order of

50

1

None of these

100

50

1

None of these

100

ANSWER DOWNLOAD EXAMIANS APP

SSC JE Electrical 2018 with solution SET-1
Which of the following is a static exciter?

Rectifier

Metadyne

DC Separately excited generator

Amplidyne

Rectifier

Metadyne

DC Separately excited generator

Amplidyne

ANSWER EXPLANATION DOWNLOAD EXAMIANS APP

An AC or DC generator requires direct current to energize its magnetic field. The DC field current is obtained from a separate source called an exciter. Either rotating or static-type exciters are used for AC power generation systems. There are two types of rotating exciters: brush and brushless. The primary difference between brush and brushless exciters is the method used to transfer DC exciting current to the generator fields. Static excitation for the generator fields is provided in several forms including field-flash voltage from storage batteries and voltage from a system of solid-state components. DC generators are either separately excited or self-excited.
EXCITATION SYSTEMS in current use include direct-connected or gear-connected shaft-driven DC generators, belt-driven or separate prime mover or motor-driven DC generators, and DC supplied through static rectifiers.
Static Excitation System
As the name indicates, all the components in this type of excitation system are static. A set of rectifiers is fed from a transformer that steps down the main generator or auxiliary bus voltage. The rectifiers supply the main generator excitation current directly through slip rings and they may be controlled or uncontrolled.

An external source of DC is necessary for the initial excitation of the field windings. On engine-driven generators, the initial excitation may be obtained from the storage batteries used to start the engine or from control voltage at the switchgear.
The main advantage of the static exciter is improved response as the field current is controlled directly by the thyristor rectifier but, of course, if the generator terminal voltage is depressed too low then excitation power will be lost. It is again possible to provide the power supply from both voltage and current transformers at the generator terminals but it is doubtful whether the improved response of the static exciter over a permanent magnet brushless scheme can be justified for many small embedded generators.

SSC JE Electrical 2018 with solution SET-1
Which one of the material is used to fix the screw on concrete wall and ceiling?

Bushings

Link clips

Saddles

Rawl Plug

Bushings

Link clips

Saddles

Rawl Plug

ANSWER EXPLANATION DOWNLOAD EXAMIANS APP

SSC JE Electrical 2018 with solution SET-1
Determine the voltage (in V) of a battery connected to a parallel plate capacitor (filled with air) when the area of the plate is 10 square centimeters, the separation between the plate is 5 mm and the charged stored on the plate is 20 pC

11.3

12.3

14.3

10.3

11.3

12.3

14.3

10.3

ANSWER EXPLANATION DOWNLOAD EXAMIANS APP

SSC JE Electrical 2018 with solution SET-1

SSC JE Electrical 2018 with solution SET-1 Which of the following is used for the measurement of the insulation resistance?

SSC JE Electrical 2018 with solution SET-1 Scott connections are used for

SSC JE Electrical 2018 with solution SET-1 The output Resistance (in kΩ) of the common base transistor is of the order of

SSC JE Electrical 2018 with solution SET-1 Which of the following is a static exciter?

SSC JE Electrical 2018 with solution SET-1 Which one of the material is used to fix the screw on concrete wall and ceiling?

SSC JE Electrical 2018 with solution SET-1 Determine the voltage (in V) of a battery connected to a parallel plate capacitor (filled with air) when the area of the plate is 10 square centimeters, the separation between the plate is 5 mm and the charged stored on the plate is 20 pC

SSC JE Electrical 2018 with solution SET-1
Which of the following is used for the measurement of the insulation resistance?

SSC JE Electrical 2018 with solution SET-1
Scott connections are used for

SSC JE Electrical 2018 with solution SET-1
The output Resistance (in kΩ) of the common base transistor is of the order of

SSC JE Electrical 2018 with solution SET-1
Which of the following is a static exciter?

SSC JE Electrical 2018 with solution SET-1
Which one of the material is used to fix the screw on concrete wall and ceiling?

SSC JE Electrical 2018 with solution SET-1
Determine the voltage (in V) of a battery connected to a parallel plate capacitor (filled with air) when the area of the plate is 10 square centimeters, the separation between the plate is 5 mm and the charged stored on the plate is 20 pC