Measurement and Instrumentation Which devices used to measure the temperature of an object ? Thermometers Poteintiometer Galvanometer Odometer Thermometers Poteintiometer Galvanometer Odometer ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A single phase load is connected between R and Y terminals of a 415 V, symmetrical, 3-phase, 4 wire system with phase sequence RYB. A wattmeter is connected in the system as shown in figure. The power factor of the load is 0.8 lagging. The wattmeter will read - 597 W. + 795 W. - 795 W. + 597 W. - 597 W. + 795 W. - 795 W. + 597 W. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation In two wattmeter method of power measurement if the total power is measured by one wattmeter only then power factor of the system is 0. 0.5. none of above. 1. 0. 0.5. none of above. 1. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation When checked with an ohm meter an open resistor reads zero. low but not zero. infinite. high but within tolerance. zero. low but not zero. infinite. high but within tolerance. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation An ammeter of range 0-25 A has a guaranteed accuracy of 1% of full-scale reading. The current measured by the ammeter is 5 A. The limiting error in the reading is 4% 6% 3% 5% 4% 6% 3% 5% ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The spring material used in a spring control device should have the following property. All of the listed here Should have low specific resistance Should non magnetic Most be of low temperature co-efficient All of the listed here Should have low specific resistance Should non magnetic Most be of low temperature co-efficient ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS