Computer Networking
When setting up Frame Relay for point-to-point subinterfaces, which of the following must not be configured?

PAP
The Frame Relay encapsulation on the physical interface
The subinterface type as point-to-point
An IP address on the physical interface
The local DLCI on each subinterface

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
If a switch receives a frame and the source MAC address is not in the MAC address table but the destination address is, what will the switch do with the frame?

Flood the network with the frame
Add the destination to the MAC address table and then forward the frame
Add the source address and port to the MAC address table and forward the frame out the destination port
Discard it and send an error message back to the originating host

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
RS-232-G

requires only 7 pin out of 25 in order to transmit digital data over public telephone lines
None of these
specifies only the mechanical characteristics of an interface by providing a 25-pin connector
is an interface standard between Data terminal Equipment and Data Circuit Terminating Equipment
is an interface between two data circuit terminating equipment as examplified by a local and remote modem

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
Error detecting code is

None of these
a code in which each expression conforms to specify rules of construction, so that if certain errors occur in an expression, the resulting expression will not conform to the rules of construction and
the ratio of the data units in error to the total number of data units
a check bit appended to an array of binary digits to make the sum of all the binary digits.
an error-detecting code based on a summation operation performed on the bits to be checked

ANSWER DOWNLOAD EXAMIANS APP

Computer Networking
Which of the following characteristic(s) is/are suited to the PSS applications?

widely dispersed terminals and access to international packets switched services
Multiple remote host or applications accessed by a single local access circuit terminal and circuit
bursty traffic and low communications intensity
None of these
All of these

ANSWER DOWNLOAD EXAMIANS APP