Computer Networking Examples are packet switching using frame relay, and cell switching using ATM technologies. Select the best fit for answer: Bandwidth alternatives Inter organizational networks Extranets None of these Switching alternating Bandwidth alternatives Inter organizational networks Extranets None of these Switching alternating ANSWER DOWNLOAD EXAMIANS APP
Computer Networking What is the purpose of flow control? To regulate the size of each segment. To ensure that data is retransmitted if an acknowledgment is not received. To provide a means for the receiver to govern the amount of data sent by the sender. To reassemble segments in the correct order at the destination device. To regulate the size of each segment. To ensure that data is retransmitted if an acknowledgment is not received. To provide a means for the receiver to govern the amount of data sent by the sender. To reassemble segments in the correct order at the destination device. ANSWER DOWNLOAD EXAMIANS APP
Computer Networking The communication mode that supports two-way traffic but only one direction at a time is simplex None of these half duplex duplex multiplex simplex None of these half duplex duplex multiplex ANSWER DOWNLOAD EXAMIANS APP
Computer Networking Bulletin board system is a public access message system converts digital signals to analog signals converts analog signals to digital signals is a modem capable of accepting commands None of these is a public access message system converts digital signals to analog signals converts analog signals to digital signals is a modem capable of accepting commands None of these ANSWER DOWNLOAD EXAMIANS APP
Computer Networking What is the maximum distance running the lowest data rate for 802.11b? About 350 feet About 175 feet About 100 feet About 300 feet About 350 feet About 175 feet About 100 feet About 300 feet ANSWER DOWNLOAD EXAMIANS APP
Computer Networking A network administrator is connecting hosts A and B directly through their Ethernet interfaces, as shown in the illustration. Ping attempts between the hosts are unsuccessful. What can be done to provide connectivity between the hosts?1. A crossover cable should be used in place of the straight-through cable.2. A rollover cable should be used in place of the straight-through cable.3. The subnet masks should be set to 255.255.255.192.4. A default gateway needs to be set on each host.5. The subnet masks should be set to 255.255.255.0. 1 only 1 and 5 only 2 only 3 and 4 only 2 and 5 only 1 only 1 and 5 only 2 only 3 and 4 only 2 and 5 only ANSWER DOWNLOAD EXAMIANS APP