Engineering Drawing When drawing a line using the relative coordinate system a line is created from ________. None of these 0, 0 The ending point of the last line The beginning point of the last line None of these 0, 0 The ending point of the last line The beginning point of the last line ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing This is a rounded exterior blend between surfaces: Round Chamfer Taper Fillet Round Chamfer Taper Fillet ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing These are lines drawn on a map to locate, in the plan view, points of equal ground elevation: Hatches Profiles Elevations Contours Hatches Profiles Elevations Contours ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Two-point perspective is also known as: Parallel perspective Angular perspective Regular perspective Two-view perspective Parallel perspective Angular perspective Regular perspective Two-view perspective ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing When only a small section of an interior area needs to be revealed the drafter can use a ________ section. Quarter Broken out Half Full Quarter Broken out Half Full ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Referring to the fractional inches to decimal inches to millimeter conversion chart on page 55 what is the equivalent mm measurement of 3/16 inch. 5.958 4.7625 1.906 14.6844 5.958 4.7625 1.906 14.6844 ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS