Analog Electronics What is the condition if no external potential energy is applied to the PN junction then diode ? Zero Bias Forward biased Reversed biased None of these Zero Bias Forward biased Reversed biased None of these ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics The input voltage to an emitter follower is usually less than the generator voltage. equal to the generator voltage. greater than the generator voltage. equal to the supply voltage. less than the generator voltage. equal to the generator voltage. greater than the generator voltage. equal to the supply voltage. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics A diode (p-n junction) when reverse biased act as On Switch Off Switch Zener diode Capacitor On Switch Off Switch Zener diode Capacitor ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics What is the most important fact about the collector current? It is measured in milliampere. It is small. It approximately equals the emitter current. It equals the base current divided by the current gain. It is measured in milliampere. It is small. It approximately equals the emitter current. It equals the base current divided by the current gain. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics When the base resistor increases, the collector voltage will probably All of these decrease. stay the same. increase. All of these decrease. stay the same. increase. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics A 3 - phase diode bridge rectifier is fed from a 400 V rms, 50 Hz, 3 phase AC source. If the load is purely resistive, then peak instantaneous output voltage is equal to 400√ (2/3) V. 400 / √ 3 V. 400 V. 400√ 2 V. 400√ (2/3) V. 400 / √ 3 V. 400 V. 400√ 2 V. ANSWER DOWNLOAD EXAMIANS APP