Engineering Materials The unit cells Have the same orientation and their similar faces are parallel May be defined as the smallest parallelepiped which could be transposed in three coordinate directions to build up the space lattice All of these Contain the smallest number of atoms which when taken together have all the properties of the crystals of the particular metal Have the same orientation and their similar faces are parallel May be defined as the smallest parallelepiped which could be transposed in three coordinate directions to build up the space lattice All of these Contain the smallest number of atoms which when taken together have all the properties of the crystals of the particular metal ANSWER DOWNLOAD EXAMIANS APP
Engineering Materials Manganese is added in low carbon steel to Raise the yield point Make the steel tougher and harder Make the steel ductile and of good bending qualities All of these Raise the yield point Make the steel tougher and harder Make the steel ductile and of good bending qualities All of these ANSWER DOWNLOAD EXAMIANS APP
Engineering Materials Manganese in steel increases its Ductility Tensile strength Hardness Fluidity Ductility Tensile strength Hardness Fluidity ANSWER DOWNLOAD EXAMIANS APP
Engineering Materials Drop forging dies contain carbon of the order of 0.7 to 0.9% 0.1 to 0.2% 0.25 to 0.5% 0.6 to 0.7% 0.7 to 0.9% 0.1 to 0.2% 0.25 to 0.5% 0.6 to 0.7% ANSWER DOWNLOAD EXAMIANS APP
Engineering Materials In process annealing, the hypo eutectoid steel is Heated from 30°C to 50°C above the upper critical temperature and then cooled in still air Heated below or closes to the lower critical temperature and then cooled slowly Heated from 30°C to 50°C above the upper critical temperature and then cooled slowly in the furnace Heated from 30°C to 50°C above the upper critical temperature and then cooled suddenly in a suitable cooling medium Heated from 30°C to 50°C above the upper critical temperature and then cooled in still air Heated below or closes to the lower critical temperature and then cooled slowly Heated from 30°C to 50°C above the upper critical temperature and then cooled slowly in the furnace Heated from 30°C to 50°C above the upper critical temperature and then cooled suddenly in a suitable cooling medium ANSWER DOWNLOAD EXAMIANS APP
Engineering Materials Stress relaxation is the phenomenon In which parts are not loaded In which deformation tends to loosen the joint and produces a stress reduced In which stress remains constant on increasing load Stress reduces on increasing load In which parts are not loaded In which deformation tends to loosen the joint and produces a stress reduced In which stress remains constant on increasing load Stress reduces on increasing load ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS