Manufacturing And Production Technology The tool life in case of a grinding wheel is the time Between two successive regrinds of the wheel Taken for the wheel to be balanced Taken between two successive wheel dressings Taken for a wear of 1 mm on its diameter Between two successive regrinds of the wheel Taken for the wheel to be balanced Taken between two successive wheel dressings Taken for a wear of 1 mm on its diameter ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Flank wear occurs mainly on the Face of the cutting tool at a short distance from the cutting edge Cutting edge only Front face only Nose part, front relief face and side relief face of the cutting tool Face of the cutting tool at a short distance from the cutting edge Cutting edge only Front face only Nose part, front relief face and side relief face of the cutting tool ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology For turning internal tapers, the suitable method is By a form tool By a taper turning attachment By setting over the tail stock By swiveling the compound rest By a form tool By a taper turning attachment By setting over the tail stock By swiveling the compound rest ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be Doubled Halved Quadrupled Unchanged Doubled Halved Quadrupled Unchanged ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In order to have interference fit, it is essential that the lower limit of the shaft should be Lesser than the lower limit of the hole Greater than the upper limit of the hole Lesser than the upper limit of the hole Greater than the lower limit of the hole Lesser than the lower limit of the hole Greater than the upper limit of the hole Lesser than the upper limit of the hole Greater than the lower limit of the hole ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Flank wear depends upon the Hardness of the work and tool material at the operating temperature All of these Amount and distribution of hard constituents in the work material Degree of strain hardening in the chip Hardness of the work and tool material at the operating temperature All of these Amount and distribution of hard constituents in the work material Degree of strain hardening in the chip ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS