Manufacturing And Production Technology In a single point tool, the angle between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base, is known as Side rake angle Side relief angle End relief angle Back rake angle Side rake angle Side relief angle End relief angle Back rake angle ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be Quadrupled Halved Unchanged Doubled Quadrupled Halved Unchanged Doubled ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Relief angles on high speed steel tools usually vary from 3° to 10° 20° to 30° 0° to 3° 10° to 20° 3° to 10° 20° to 30° 0° to 3° 10° to 20° ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology When 3-2-1 principle is used to support and locate a three dimensional work-piece during machining, the number of degrees of freedom that are restricted is 9 10 7 8 9 10 7 8 ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The grinding wheel speed (surface speed in m/min) usually varies from 500 to 1000 2000 to 2500 1500 to 2000 1000 to 1500 500 to 1000 2000 to 2500 1500 to 2000 1000 to 1500 ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The capacity of a material to be welded under the imposed fabrication conditions into a specific, suitably designed structure and to perform satisfactorily in the intended service is known as? Weldability Weldment Weld tab Tack weld Weldability Weldment Weld tab Tack weld ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS