Machine Design The rolling contact bearings are known as Plastic bearings Thin lubricated bearings Antifriction bearings Thick lubricated bearings Plastic bearings Thin lubricated bearings Antifriction bearings Thick lubricated bearings ANSWER DOWNLOAD EXAMIANS APP
Machine Design A double fillet welded joint with parallel fillet weld of length 'l' and leg 's' is subjected to a tensile force 'P'. Assuming uniform stress distribution, the shear stress in the weld is given by P/2.s.l 2P/s.l √2P/s.l P/√2.s.l P/2.s.l 2P/s.l √2P/s.l P/√2.s.l ANSWER DOWNLOAD EXAMIANS APP
Machine Design The initial tension (in newtons) in a bolt used for making a fluid tight joint like steam engine cover joints, is calculated by the relation (where d = Nominal diameter of bolt in mm) 1680 d 2840 d 1420 d 2080 d 1680 d 2840 d 1420 d 2080 d ANSWER DOWNLOAD EXAMIANS APP
Machine Design The edges of a boiler plate are bevelled to an angle of 80° 45° 30° 60° 80° 45° 30° 60° ANSWER DOWNLOAD EXAMIANS APP
Machine Design If P1 and P2 are the tight and slack side tensions in the belt, then the initial tension Pi (according to Barth) will be equal to (Where, Pc is centrifugal tension) ⅟₂× (P1 + P2) P1 + P2 [⅟₂ × (P1 + P2)] + Pc [(√P1 + √P2)/2]² ⅟₂× (P1 + P2) P1 + P2 [⅟₂ × (P1 + P2)] + Pc [(√P1 + √P2)/2]² ANSWER DOWNLOAD EXAMIANS APP
Machine Design A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where σ = Stress for a plate with no hole i.e. nominal stress) σ [1 + (b/2a)] σ [1 + (3a/b)] σ [1 + (2a/b)] σ [1 + (b/3a)] σ [1 + (b/2a)] σ [1 + (3a/b)] σ [1 + (2a/b)] σ [1 + (b/3a)] ANSWER DOWNLOAD EXAMIANS APP