Machine Design The property of a material which enables it to be drawn into wires with the application of a tensile force, is called Ductility Plasticity Elasticity Malleability Ductility Plasticity Elasticity Malleability ANSWER DOWNLOAD EXAMIANS APP
Machine Design The usual proportion for the width of key is (where d = Diameter of shaft or diameter of hole in the hub) d/6 d/4 d/8 d/2 d/6 d/4 d/8 d/2 ANSWER DOWNLOAD EXAMIANS APP
Machine Design In a partial journal bearing, the angle of contact of the bearing with the journal is 270° 360° 120° 180° 270° 360° 120° 180° ANSWER DOWNLOAD EXAMIANS APP
Machine Design The constant factor in case of R10 series of preferred numbers is 1.58 1.06 1.12 1.26 1.58 1.06 1.12 1.26 ANSWER DOWNLOAD EXAMIANS APP
Machine Design A shaft coupling should Hold the shafts in perfect alignment Be easy to connect or disconnect All of these Transmit full power of the shaft Hold the shafts in perfect alignment Be easy to connect or disconnect All of these Transmit full power of the shaft ANSWER DOWNLOAD EXAMIANS APP
Machine Design Which one of the following is a positive drive? V-belt drive Rope drive Crossed flat belt drive Chain drive V-belt drive Rope drive Crossed flat belt drive Chain drive ANSWER DOWNLOAD EXAMIANS APP