Machine Design
The notch sensitivity q is expressed in terms of fatigue stress concentration factor Kf and theoretical stress concentration factor Kt as

(Kt + 1)/ (Kf + 1)
(Kf - 1)/ (Kt - 1)
(Kt - 1)/ (Kf - 1)
(Kf + 1)/ (Kt + 1)

ANSWER DOWNLOAD EXAMIANS APP

Machine Design
In replacing the V-belts, a complete set of new belts is used instead of replacing a single damaged belt because

New and old belts will cause vibrations
Belts are available in sets
Only one belt cannot be fitted with other used belts
The new belt will carry more than its share and result in short life

ANSWER DOWNLOAD EXAMIANS APP

Machine Design
The flank of the tooth is the

Surface of the tooth below the pitch surface
Width of the tooth measured along the pitch circle
Surface of the tooth above the pitch surface
Surface of the top of the tooth

ANSWER DOWNLOAD EXAMIANS APP

Machine Design
Jam nut is a locking device in which

One smaller nut is tightened over main nut and main nut tightened against smaller one by loosening, creating friction jamming
A slot is cut partly in middle of nut and then slot reduced by tightening a screw
A hard fibre or nylon cotter is recessed in the nut and becomes threaded as the nut is screwed on the bolt causing a tight grip
Through slots are made at top and a cotter pin is passed through these and a hole in the bolt, and cotter spitted and bent in reverse direction at other end

ANSWER DOWNLOAD EXAMIANS APP