Measurement and Instrumentation The electrical power to a megger is provided by Permanent magnet dc generator Battery Any of the listed here Ac generator Permanent magnet dc generator Battery Any of the listed here Ac generator ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The adjustment of position of shading bands, in an energy meter is done to provide None of the listed here Friction compensation Breaking torque Creep compensation None of the listed here Friction compensation Breaking torque Creep compensation ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A slide wire potentiometer has 10 wires of 1 m each. With the help of a standard voltage source of 1.018 V it is standardised by keeping the jockey at 101.8 cm. If the resistance of the potentiometer wires is 1000 ohm, then the value of the working current will be 100 mA. 0.5 mA. 1mA. 10 mA. 100 mA. 0.5 mA. 1mA. 10 mA. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The operating voltage of a megger is about 40 V 6 V 12 V 100 V 40 V 6 V 12 V 100 V ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation In a ballistic galvanometer, the deflecting torque is proportional to The current through coil Square of current through coil Sine of measured Square-root of current through coil The current through coil Square of current through coil Sine of measured Square-root of current through coil ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The time/div and voltage axes of an oscilloscope have been creased. A student connects a 1 KHz, 5 V P-P square wave calibrition pulse to channel-1 of the scope and observes the screen to be as shown in the upper trace of figure. An unknown signal is connected to channel-2 (lower trace) of the scope. If the time/div and V/div on both channels are the same, the amplitude (P-P) and period of the unknown signal are respectively 10 V, 1 ms. 5 V, 1 ms. 7.5 V, 2 ms. 5 V, 2 ms. 10 V, 1 ms. 5 V, 1 ms. 7.5 V, 2 ms. 5 V, 2 ms. ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS