Steam Boilers, Engines, Nozzles and Turbines The efficiency of steam turbines may be improved by Any one of these Binary vapor plant Regenerative feed heating Reheating of steam Any one of these Binary vapor plant Regenerative feed heating Reheating of steam ANSWER DOWNLOAD EXAMIANS APP
Steam Boilers, Engines, Nozzles and Turbines Which is not correct statement about effect of sulphur in fuel? It erodes furnace walls It has heating value It helps in electrostatic precipitation of ash in flue gases It leads to corrosion of air heaters, ducting, etc. if flue gas exit temperature is low It erodes furnace walls It has heating value It helps in electrostatic precipitation of ash in flue gases It leads to corrosion of air heaters, ducting, etc. if flue gas exit temperature is low ANSWER DOWNLOAD EXAMIANS APP
Steam Boilers, Engines, Nozzles and Turbines Relative percentage of heat absorbed through the heat transfer of(i) Furnace water wall(ii) Boiler tank(iii) Superheater(iv) Economizer(v) Air-heater of a typical boiler of 200 MW capacity would be of the order of 48 : 20 : 15 : 7 : 10 7 : 15 : 20 : 10 : 48 20 : 48 : 7 : 15 : 10 10 : 7 : 15 : 20 : 48 48 : 20 : 15 : 7 : 10 7 : 15 : 20 : 10 : 48 20 : 48 : 7 : 15 : 10 10 : 7 : 15 : 20 : 48 ANSWER DOWNLOAD EXAMIANS APP
Steam Boilers, Engines, Nozzles and Turbines The isentropic enthalpy drop in moving blade is two-third of the isentropic enthalpy drop in fixed blades of a turbine. The degree of reaction will be 0.56 0.67 1.67 0.4 0.56 0.67 1.67 0.4 ANSWER DOWNLOAD EXAMIANS APP
Steam Boilers, Engines, Nozzles and Turbines Which of the following statement is correct for a compound steam engine? The forces in the working parts are increased as the forces are distributed over more parts The temperature range per cylinder is increased, with corresponding increase in condensation The ratio of expansion is reduced, thus reducing the length of stroke The cost of the engine, for the same power and economy, is more than that of a simple steam engine The forces in the working parts are increased as the forces are distributed over more parts The temperature range per cylinder is increased, with corresponding increase in condensation The ratio of expansion is reduced, thus reducing the length of stroke The cost of the engine, for the same power and economy, is more than that of a simple steam engine ANSWER DOWNLOAD EXAMIANS APP
Steam Boilers, Engines, Nozzles and Turbines The effect of friction in the nozzle ___ dryness fraction of steam. None of the listed here Decreases Increases Has no effect on None of the listed here Decreases Increases Has no effect on ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS