Manufacturing And Production Technology The carbide tools operating at very low cutting speeds (below 30 m/min) Have no effect on tool life Reduces tool life Spoils the work piece Increases tool life Have no effect on tool life Reduces tool life Spoils the work piece Increases tool life ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The width of cutting edge of a parting off tool varies from 8 to 30 mm 3 to 12 mm 15 to 40 mm 5 to 20 mm 8 to 30 mm 3 to 12 mm 15 to 40 mm 5 to 20 mm ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The relation between tool life (T) and cutting speed (V) is VTn = Constant. In this relation, the value of n depends upon Work material Working conditions Tool material Type of chip produced Work material Working conditions Tool material Type of chip produced ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The machining of titanium is difficult due to Low tool-chip contact area High thermal conductivity of titanium None of these Chemical reaction between tool and work Low tool-chip contact area High thermal conductivity of titanium None of these Chemical reaction between tool and work ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The cutting force in up milling ___ per tooth movement of the cutter. Increases from zero to maximum Is zero Is maximum Decreases from maximum to zero Increases from zero to maximum Is zero Is maximum Decreases from maximum to zero ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The abrasive slurry used in ultrasonic machining contains fine particles of Aluminium oxide Boron carbide All of the listed here Silicon carbide Aluminium oxide Boron carbide All of the listed here Silicon carbide ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS