Machine Design The building up of worn and undersized parts, subjected to repeated loads by electroplating is Has no effect as regards fatigue strength Cheapest method Extremely hazardous Best method Has no effect as regards fatigue strength Cheapest method Extremely hazardous Best method ANSWER DOWNLOAD EXAMIANS APP
Machine Design When an open coiled helical compression spring is subjected to an axial compressive load, the stress induced in the wire is Bending stress Tensile stress Compressive stress Shear stress Bending stress Tensile stress Compressive stress Shear stress ANSWER DOWNLOAD EXAMIANS APP
Machine Design The velocity factor for ordinary cut gears operating at velocities up to 12.5 m/s is equal to 6/(6 + v) 0.75/(0.75 + √v) 3/(3 + v) 4.5/(4.5 + v) 6/(6 + v) 0.75/(0.75 + √v) 3/(3 + v) 4.5/(4.5 + v) ANSWER DOWNLOAD EXAMIANS APP
Machine Design A flanged pipe joint will be a leak-proof joint, if the circumferential pitch of the bolts is (where d = Diameter of bolt hole) Between 20d and 30d Equal to inside diameter of pipe Greater than 30d Less than 20d Between 20d and 30d Equal to inside diameter of pipe Greater than 30d Less than 20d ANSWER DOWNLOAD EXAMIANS APP
Machine Design If threads on a bolt are left hand, threads on nut will be Right hand with same pitch Right hand with fine pitch Could be left or right hand Left hand with same pitch Right hand with same pitch Right hand with fine pitch Could be left or right hand Left hand with same pitch ANSWER DOWNLOAD EXAMIANS APP
Machine Design The endurance limit in shear of carbon steel can be obtained by multiplying the endurance limit in flexure by a factor of 0.65 0.75 0.45 0.55 0.65 0.75 0.45 0.55 ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS