Process Control and Instrumentation __________ stability method uses open loop transfer function. None of these Ruth Nyquist Mikhalov None of these Ruth Nyquist Mikhalov ANSWER DOWNLOAD EXAMIANS APP
Process Control and Instrumentation The characteristic equation for the control system with a closed loop transfer function Gā/1 + Gā is given by 1 + Gā = 0. The characteristic equation for the control system Is the same for set point or load changes Depends only upon the open loop transfer function All of these Determines its stability Is the same for set point or load changes Depends only upon the open loop transfer function All of these Determines its stability ANSWER DOWNLOAD EXAMIANS APP
Process Control and Instrumentation Positioning controllers are used for Temperature changes Low loads High loads Flow rate changes Temperature changes Low loads High loads Flow rate changes ANSWER DOWNLOAD EXAMIANS APP
Process Control and Instrumentation Hot wire anemometer is used for the measurement of Flow rates of fluids Flow rates of granular solids Thermal conductivity of gases Very high temperature Flow rates of fluids Flow rates of granular solids Thermal conductivity of gases Very high temperature ANSWER DOWNLOAD EXAMIANS APP
Process Control and Instrumentation Liquid discharge from a tank or reservoir can not be measured by Notches Mouthpieces Orificemeters Weirs Notches Mouthpieces Orificemeters Weirs ANSWER DOWNLOAD EXAMIANS APP
Process Control and Instrumentation Which of the following controllers has the least maximum deviation? P-I-D controller P-controller P-I controller P-D controller P-I-D controller P-controller P-I controller P-D controller ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS