The operation of cutting of a flat sheet to the desired shape is called Blanking Shearing Punching Piercing TRUE ANSWER : ? YOUR ANSWER : ?
According to Indian standards, the total numbers of tolerance grades are 12 8 18 20 TRUE ANSWER : ? YOUR ANSWER : ?
Loam sand is a mixture of 90% sand and 10% clay 50% sand and 50% clay 70% sand and 30% clay 30% sand and 70% clay TRUE ANSWER : ? YOUR ANSWER : ?
The mode of deformation of the metal during spinning is Stretching Bending and stretching Bending Rolling and stretching TRUE ANSWER : ? YOUR ANSWER : ?
In a compound die Two or more cutting operations are performed at one station of the press in every stroke of the ram Only one operation is performed at each stroke of the ram Both cutting and non-cutting operations are performed at one station of the press in every stroke of the ram Two or more operations are performed simultaneously at the single stroke of the ram TRUE ANSWER : ? YOUR ANSWER : ?
V-block is used to None of these Locate centres of round rods Check the surface roughness Check the trueness of flat surfaces TRUE ANSWER : ? YOUR ANSWER : ?
In arc welding, the temperature of heat produced by the electric arc is of the order of 5000°C to 6000°C 4000°C to 5000°C 3000°C to 4000°C 6000°C to 7000°C TRUE ANSWER : ? YOUR ANSWER : ?
In forehand welding, the angle between the welding torch and the work is ________ as compared to backhand welding. None of these Same Less More TRUE ANSWER : ? YOUR ANSWER : ?
A sand employed on the faces of the pattern before moulding, is called Loam sand Green sand Parting sand Dry sand TRUE ANSWER : ? YOUR ANSWER : ?