Machine Design Oil in journal bearing should be applied at the point where load is Nil or lightest Average Maximum Any one of the above Nil or lightest Average Maximum Any one of the above ANSWER DOWNLOAD EXAMIANS APP
Machine Design Stress concentration in cyclic loading is more serious in Ductile materials Brittle materials Depends on other factors Equally serious in both cases Ductile materials Brittle materials Depends on other factors Equally serious in both cases ANSWER DOWNLOAD EXAMIANS APP
Machine Design The belt slip occurs due to Heavy load Any one of the above Driving pulley too small Loose belt Heavy load Any one of the above Driving pulley too small Loose belt ANSWER DOWNLOAD EXAMIANS APP
Machine Design Idler pulley is used for Changing the direction of motion of belt All of these For applying tension Increasing velocity ratio Changing the direction of motion of belt All of these For applying tension Increasing velocity ratio ANSWER DOWNLOAD EXAMIANS APP
Machine Design When the material of key and shaft is same, and the width of key is one-fourth of the diameter of shaft (d), then length of key will be 1.2 d 0.8 d 1.57 d 1.8 d 1.2 d 0.8 d 1.57 d 1.8 d ANSWER DOWNLOAD EXAMIANS APP
Machine Design In order to have smooth operation, the minimum number of teeth on the smaller sprocket, for moderate speeds, should be 25 15 21 17 25 15 21 17 ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS