Engineering Drawing Inserting blocks into a drawing file usually requires exacting placement. The drafter should insure that ________ is turned on. Dynamic Input O Snaps Ortho Grid Dynamic Input O Snaps Ortho Grid ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing To avoid having to dimension to a hidden feature the drafter can utilize a ________ section. All of these Half Broken out Whole All of these Half Broken out Whole ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing In this type of concrete, the steel is pre-tensioned before the superimposed load is applied: Pre-stressed Aggregate Reinforced Preloaded Pre-stressed Aggregate Reinforced Preloaded ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Drawings created with commercial software are typically saved as: Electronic files Change orders Draft drawings Rapid prototypes Electronic files Change orders Draft drawings Rapid prototypes ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing When using the descriptive geometry method to create an auxiliary view the drafter should _________. Offset the top line of the front view 2 inches Offset the right vertical line of the front view Rotate the snap grid to the same angle of the inclined plane Rotate the top line of the front view 45 degrees Offset the top line of the front view 2 inches Offset the right vertical line of the front view Rotate the snap grid to the same angle of the inclined plane Rotate the top line of the front view 45 degrees ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________. 1/4" = 1'-0" 3/4" = 1'-0" 1" = 100' 1/8" = 1'-0" 1/4" = 1'-0" 3/4" = 1'-0" 1" = 100' 1/8" = 1'-0" ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS