Engineering Drawing In this type of projection, each of the axes has different ratios of foreshortening: Parallel Dimetric Isometric Trimetric Parallel Dimetric Isometric Trimetric ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing When using the direct entry method to create a horizontal line exactly three inches long the drafter should ________ first. Insure that Ortho is on Pull the line from away from the starting point very carefully Read the coordinate position on the Dynamic Readout Enter 3 for the length of the line Insure that Ortho is on Pull the line from away from the starting point very carefully Read the coordinate position on the Dynamic Readout Enter 3 for the length of the line ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing When creating an isometric drawing in Auto-CAD the drafter can utilize the Dynamic Input and Polar Coordinate system to place both vertical and horizontal lines. A line created from one point 3 inches at 180 degrees would be a ________ line. None of these Vertical Inclined Horizontal None of these Vertical Inclined Horizontal ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Acceptable parts must not extend beyond this: Tolerances Boundary limits Hole limits Specification Tolerances Boundary limits Hole limits Specification ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing In U.S. structural and architectural drafting, all dimensions of this length are usually expressed in feet and inches: One foot or over One rod or over One yard or over One inch or over One foot or over One rod or over One yard or over One inch or over ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing These maps are used in planning installations of trees, shrubbery, drives, and other garden features: Cadastral maps Landscape maps Engineering maps Topographic maps Cadastral maps Landscape maps Engineering maps Topographic maps ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS