Manufacturing And Production Technology In metal machining, the zone where the maximum heat is generated due to the plastic deformation of metal, is called Work-tool contact zone None of these Shear zone Friction zone Work-tool contact zone None of these Shear zone Friction zone ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The tool life is affected by All of the listed here Cutting speed Depth of cut Feed All of the listed here Cutting speed Depth of cut Feed ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology When 3-2-1 principle is used to support and locate a three dimensional work-piece during machining, the number of degrees of freedom that are restricted is 9 8 7 10 9 8 7 10 ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In DC arc welding, if leads are arranged in work as Negative pole of the welding arc and electrode as Positive pole of the welding arc, the arrangement is known as Forward welding Reverse polarity Fusion Direct polarity Forward welding Reverse polarity Fusion Direct polarity ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology When two main plates are kept in alignment butting each other and riveted with cover plate on both sides of the main plates with two rows of rivets in each main plate, the joint is known as _______ double cover butt joint. None of these Double riveted Both (A) and (B) Single riveted None of these Double riveted Both (A) and (B) Single riveted ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In order to have interference fit, it is essential that the lower limit of the shaft should be Lesser than the upper limit of the hole Greater than the lower limit of the hole Greater than the upper limit of the hole Lesser than the lower limit of the hole Lesser than the upper limit of the hole Greater than the lower limit of the hole Greater than the upper limit of the hole Lesser than the lower limit of the hole ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS