Machine Design In helical gears, the distance parallel to the axis, between similar faces of adjacent teeth, is called Diametral pitch Normal pitch Module Axial pitch Diametral pitch Normal pitch Module Axial pitch ANSWER DOWNLOAD EXAMIANS APP
Machine Design A shaft is subjected to a maximum bending stress of 80 N/mm² and maximum shearing stress equal to 30 N/mm² at a particular section. If the yield point in tension of the material is 280 N/mm² and the maximum shear stress theory of failure is used, then the factor of safety obtained will be 2.5 2.8 3.0 3.5 2.5 2.8 3.0 3.5 ANSWER DOWNLOAD EXAMIANS APP
Machine Design Turn buckle has Left hand threads on both ends Right hand threads on bout ends No threads Left hand threads on one end and right hand threads on other end Left hand threads on both ends Right hand threads on bout ends No threads Left hand threads on one end and right hand threads on other end ANSWER DOWNLOAD EXAMIANS APP
Machine Design According to Indian standard specifications, a Grey cast iron designated by 'FG 200' means that the Maximum shear strength is 200 N/mm² Minimum tensile strength is 200 N/mm² Maximum compressive strength is 200 N/mm² Carbon content is 2% Maximum shear strength is 200 N/mm² Minimum tensile strength is 200 N/mm² Maximum compressive strength is 200 N/mm² Carbon content is 2% ANSWER DOWNLOAD EXAMIANS APP
Machine Design In the calculation of induced shear stress in helical springs, the Wahl's stress factor is used to take care of Combined effect of bending stress and curvature of the wire Combined effect of transverse shear stress and curvature of wire Combined effect of torsional shear stress and transverse shear stress in the wire Combined effect of transverse shear stress and bending stress in the wire Combined effect of bending stress and curvature of the wire Combined effect of transverse shear stress and curvature of wire Combined effect of torsional shear stress and transverse shear stress in the wire Combined effect of transverse shear stress and bending stress in the wire ANSWER DOWNLOAD EXAMIANS APP
Machine Design The diameter of knuckle pin in a knuckle joint is usually taken as (where d = Diameter of the rod) 1.2 d d 0.8 d 0.5 d 1.2 d d 0.8 d 0.5 d ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS