Manufacturing And Production Technology In down milling, the thickness of chip is Uniform throughout the cut Maximum at the beginning of the cut and minimum at the end of the cut None of these Minimum at the beginning of the cut and maximum at the end of the cut Uniform throughout the cut Maximum at the beginning of the cut and minimum at the end of the cut None of these Minimum at the beginning of the cut and maximum at the end of the cut ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Flank wear occurs mainly on the Front face only Face of the cutting tool at a short distance from the cutting edge Cutting edge only Nose part, front relief face and side relief face of the cutting tool Front face only Face of the cutting tool at a short distance from the cutting edge Cutting edge only Nose part, front relief face and side relief face of the cutting tool ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Carbide tipped tools usually have Negative rake angle Any rake angle No rake angle Positive rake angle Negative rake angle Any rake angle No rake angle Positive rake angle ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The tool may fail due to Cracking at the cutting edge due to thermal stresses All of these Chipping of the cutting edge Plastic deformation of the cutting edge Cracking at the cutting edge due to thermal stresses All of these Chipping of the cutting edge Plastic deformation of the cutting edge ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology EDM machining is applied for Shaping carbide dies and punches having complicated profiles Making large number of small holes in sieves and fuel nozzles Embossing and engraving on harder materials All of the listed here Shaping carbide dies and punches having complicated profiles Making large number of small holes in sieves and fuel nozzles Embossing and engraving on harder materials All of the listed here ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In orthogonal turning of a low carbon steel bar of diameter 150 mm with uncoated carbide tool, the cutting velocity is 90 m/min. The feed is 0.24 mm/rev and the depth of cut is 2 mm. The chip thickness obtained is 0.48 mm. If the orthogonal rake angle is zero and the principle cutting edge angle is 90⁰, the shear angle in degree is 26.56 36.56 20.56 30.56 26.56 36.56 20.56 30.56 ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS