Manufacturing And Production Technology In electrochemical machining, the gap between the tool and work is kept as 0.4 mm 0.1 mm 0.75 mm 0.35 mm 0.4 mm 0.1 mm 0.75 mm 0.35 mm ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The usual value of the point angle of a drill is 70° 130° 100° 118° 70° 130° 100° 118° ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Friction at the tool-chip interface can be reduced by Decreasing the cutting speed Increasing the depth of cut Increasing the cutting speed Decreasing the rake angle Decreasing the cutting speed Increasing the depth of cut Increasing the cutting speed Decreasing the rake angle ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A taper tap has None of these Full threads for the whole of its length Its end tapered for about three or four threads Its end tapered for about eight or ten threads None of these Full threads for the whole of its length Its end tapered for about three or four threads Its end tapered for about eight or ten threads ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A 15 mm drilling machine means that it can drill a hole None of these Of maximum diameter 15 mm In 15 mm thick plates None of these Of maximum diameter 15 mm In 15 mm thick plates ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Cast iron during machining produces Continuous chips with built-up edge Continuous chips None of these Discontinuous chips Continuous chips with built-up edge Continuous chips None of these Discontinuous chips ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS